Standards Division

RENEWAL OF UNLIMITED PETROLEUM DEVICE TECHNICIAN LICENSE

You must submit the renewal form to renew your unlimited Petroleum Device Technician License each year. It is important that you take immediate action in order to have your registration renewed prior to December 31, 2008. The following steps should be followed in completing the renewal form for each applicant.

1. Fill in or correct (if necessary) your complete mailing address, including zip code.

2. Fill in or correct (if necessary) employment information, including company name, mailing address and zip code.

3. Write in the state, date (month, day, and year), and test number of the latest calibration for your test measure or prover in the space provided.

Note: Your five-gallon test measure(s) must have been tested on or after October 1, 2008. Large provers for terminal meters must have been tested within the last 36 months. Dynamic small volume provers (SVPs) must have been tested within the last 12 months.

4. If your test measure or prover was not tested by North Carolina, enclose a copy of the test report from the state where it was tested. This information must be included before your license can be processed.

5. Sign the renewal form where the applicant's signature is requested.

6. Enclose with your renewal form a lead and wire seal that is embossed with your three (3) initials on one side and the year "09" on the other.
Your application cannot be processed until we receive this seal. Therefore, we suggest that you immediately order a die (embossed seal) for your hand sealer from the stamp and die or petroleum equipment dealer of your choice.

7. Return the completed renewal form to:

NCDA & CS
Standards Laboratory
1051 Mail Service Center
Raleigh, NC 27699-1051

RENEWAL OF LIMITED PETROLEUM DEVICE TECHNICIAN LICENSE

You must submit the renewal form to renew your Limited Petroleum Device Technician License each year. (This license is for those who service LP-Gas meters but do not calibrate them.) It is important that you take immediate action in order to have your registration renewed prior to December 1, 2008. The following steps should be followed in completing the renewal form for each applicant.

1. Fill in or correct (if necessary) your complete mailing address, including zip code.

2. Fill in or correct (if necessary) employment information, including company name, mailing address and zip code.

3. Sign the renewal form where the applicant's signature is requested.

4. Enclose with your renewal form a lead and wire seal that is embossed with your initials (three letters) on one side and the year "09" on the other. Your application cannot be processed until we receive this seal. Therefore, we suggest that you immediately order a die (embossed seal) for your hand sealer from the stamp and die or petroleum equipment dealer of your choice.

5. Return the completed renewal form to:

NCDA & CS
Standards Laboratory
1051 Mail Service Center
Raleigh, NC 27699-1051

Last updated September 18, 2008